Brava - Medium Duty Flail Mower

Click one of the feature numbers below.

PTO Gearbox

The Brava uses a self contained gearbox with an input speed of 540 rpm.


Back to features image

Linkage Mounting

The Brave Flail Mower uses category I three point hitches to connect to the tractor.


Back to features image

External Transmission Belt Adjustable

The Brava Flail Mower utilises 3 toothed transmission drive belts (Brava 200 model has 4 toothed drive belts) to transfer power to the rotor, the toothed drive belts allow slip proof engagement preventing power from the transmission being reduced due to heavy loads or general wear.


Back to features image

Blades And Hammer Kits

The Brave Flail Mower comes standard with hammer flails and as an option with fish tail flails, the self sharpening hammer flail leaves a clean and level cut and lifts and mulches while cutting, whereas the fish tail flail is used for cutting dense tougher material. The hammers and blades bolt onto an electronically balanced rotor that minimises machine vibration and stresses on the bearings.  

Back to features image

Counter Blade

The Brava Flail Mower comes as standard with an internal lower counter blade that ensures that the discharged material is mulched into fine pieces. The upper counter blade kits are available as an optional extra for a finer mulching of harder coarser materials.


Back to features image

Adjustable Rear Roller

The Brava Flail Mower has two rear roller positions, internal and external. The external position unloads material in front of the self cleaning roller, the roller scraper can be manually adjusted if required to suit different working conditions. The external position is recommended for straw chopping as it presses down the crop residue speeding up break down. The internal position unloads the material behind the roller and is recommended for grass cutting. As a rule the roller scraper isn’t required for the internal position as the spinning flails on the machine automatically carry out this process.


Back to features image

Front Safety Flaps

Steel front safety flaps allow material to enter the cutting chamber but prevent pieces from being thrown out at high speed.


Back to features image

Mechanical Offset

The Brava Flail Mower comes as standard with mechanical offset, it utilises a pin system to allow the 3 point linkage frame to slide along a front bar to select the offset in either a left or right direction.


Back to features image

Rear Opening Bonnet For Maintenance

The rear bonnet can be easily opened for flail and rotor inspection, this greatly improves the operator’s safety as most maintenance can be carried out with the Flail Mower on the ground.


Back to features image