Bella - Medium Duty Flail Mower

Click one of the feature numbers below.

PTO Gearbox

The Bella uses a self contained gearbox with an input speed of 540rpm, the gearbox can be reversed by unbolting and turning it over, this allows the Bella to be used as a front or rear mounted flail mower.


Back to features image

Linkage Mounting

The Bella Flail Mower uses category I three point hitches to connect to the tractor which can be easily removed and reversed or turned allowing the Bella to be either a front or rear mounted machine. A Category II upgrade kit is available as an optional extra.


Back to features image

External Transmission Belt Adjustable

The Bella Flail Mower utilises 3 toothed transmission drive belts (Bella 190 & 210 have 4 toothed drive belts) to transfer power to the rotor, the toothed drive belts allow slip proof engagement preventing power from the transmission being reduced due to heavy loads or general wear.


Back to features image

Blades And Hammer Kits

The Bella Flail Mower comes standard with hammer flails and as an option with fish tail flails, the self sharpening hammer flail leaves a clean and level cut and lifts and mulches while cutting, whereas the fish tail flail is used for cutting dense tougher material. The hammers and blades bolt onto an electronically balanced rotor that minimises machine vibration and stresses on the bearings.


Back to features image

Counter Blade

The Bella Flail Mower comes as standard with double counter blades, an internal lower toothed counter blade and one upper counter blade that ensure that the discharged material is mulched into fine pieces. The upper counter blade enables the Bella to produce a finer mulch of harder coarser materials.


Back to features image

Rear Roller

Height adjustment is controlled by the external rear roller on the Bella Fail Mower.


Back to features image

Front Safety Flaps

Steel front safety flaps allow material to enter the cutting chamber but prevent pieces from being thrown out at high speed.


Back to features image

Mechanical Offset

The Bella Flail Mower comes as standard with mechanical offset, it utilises a pin system to allow the 3 point linkage frame to slide along a front bar to select the offset in either a left or right direction.


Back to features image

Long Life Bearings

The Bella Flail Mower uses barrel roller bearings, each bearing has a double rail consisting of two rows of spherical or barrel bearings to cope with heavy workloads. All bearings used in Maschio Flail Mowers are produced by SKF.
Main Advantages:

Long Life (Up to 30% longer life than traditional taper roller bearings)

High Load Capacity (shock resistance)

Easy Maintenance (One of Maschio's main philosophies)

Back to features image